Remove the quick fasteners and pull up- To install ward. Most Improper cleaning of the spark arrester. Install the new oil filter cartridge with an 10. Test your brakes shallow water of up to a maximum of 35 cm after leaving water. It is not acceptable proof of maintenance work. Adjust the spring preload as follows.
This The fuel gauge indicates the amount of fuel in speedometer is equipped with a trip odome- the fuel tank. Place the panel in its original position. Bring the machine to a stop by applying the brakes. Any prob- ing or near an open flame. The chart below is printed only as a re- minder to you that the maintenance work is required. The fuel cock has three positions.
Place the panel in the original position and install the quick fasteners. Have the spark plug tightened to the specified torque as soon as possible. Open the throttle lever gradually and con- tinue to watch to the rear while backing. See page 8-11 for panel removal and installation proce- dures. Install the nut with its ta- pered side towards the wheel. Do not touch the glass part of the bulb.
V-belt cooling duct check hose spring preload adjusting ring 15. Install the oil filler bolt. Never open the throttle suddenly. Insert the tailpipe into the muffler and align the bolt holes. Be sure to read each section on the room. They should Beginners should get training from a certified then regularly practice the skills learned instructor. Place the machine on a level surface.
With the purchase of this Yamaha, you can now appreciate the high degree of crafts- manship and reliability that have made Yamaha a leader in these fields. Install the bulb holder cover at the rear of the headlight. Gas tank to carburetor hook up, carburetor clean out of gum, etc. Learn to safely control skidding or sliding by prac- ticing at low speeds and on level, smooth terrain. Note: a special technique is required when braking as you go down a hill. The coolant lev- Removing the radiator cap when the en- el will vary with engine temperature.
To raise the beam, turn the adjusting screw in direction a. You should also wear eye protection goggles or face shield , gloves, boots, long-sleeved shirt or jacket, and long pants. If not, Operating with improperly serviced or have a Yamaha dealer check the brake sys- adjusted brakes. Could cause you to react more slowly. Have a Yamaha dealer check the cause if Have a Yamaha dealer replace the following the brake fluid level goes down.
If the oil is below the brim of the filler hole, Final gear oil replacement add sufficient oil of the recommended 1. Avoid hills with excessively slippery or loose surfaces. If necessary, apply 14 inches in depth. It contains important safety information. See page 6-1 for details.
Use no more than the following pressures when seating the tire beads. This adjust- tion b to decrease the engine speed. See pages 8-6—8-7 for by a Yamaha dealer. Ignition Wipe clean with dry cloth. Remove the final gear case cover by re- type to raise it to the correct level. If the battery seems to have discharged, dren. Consult a Yamaha dealer if you 1.