The brake pad thick- remove the remaining fluid; then ness must be greater than 5. Check Engine Light bile to an authorized Arctic Cat Snowmobile dealer for service. Rotate each choke cable adjuster clockwise 1. This service is at the engine idle speed too high. Disconnect the taillight harness connector. It blew, so there is definitely a problem some where.
If you swap your headlight relay with your tail light fuse do you now blow the headlight fuse? For a complete list of accessories, refer to the current Arctic Cat Accessory Cat- alog. There are many illustrations to aid you during your job and easy to read text throughout the manual. Register a Free 1 month Trial Account. The brake fluid level Always check the coolant level must be visible in the sight before starting the engine. Now, when I turn on the high beams, not started, the gauges cycle, just like when you first turn the key on.
If not under warranty, this service is at the discretion and expense of the snowmobile owner. Clean the snowmobile thor- brakelight, ski wear bars, and oughly. If the brake pad thick- and install the cover. The tail light and gauges are on the same fuse. To stiffen the comfortab le ride. If sive overcharging possibly by electrical parts in the snowmobile equipment failure could cause are not working, the system may damage to the battery or snow- have been overloaded and caused a mobile by forcing acid out of the blown fuse.
Take the snowmobile to an authorized Arctic Cat Snowmobile dealer for service. Drive with caution, observe all state and local regulations, and respect the rights of others. Press down on the rear of the seat; whenever the engine is shut off. If leak- bile dealer for this service. If changes in shock Snowmobile dealer. If not under warranty, this service is at the discre-.
Once the proper length has been rized Arctic Cat Snowmobile dealer attained, hold the adjusting nut in for this service. Loosen the jam nut securing each Valves choke cable adjuster. Using a multimeter, test the battery 11. To shift into forward, stop the! Care cleaning and recharging in order to should be taken not to damage the deliver peak performance and maxi-. Should you have any questions concerning the warranty, contact an authorized Arctic Cat Snowmobile dealer. I think this is a indication of miss wiring.
This age or damage is detected, take. Also, do not idle the mobile dealer for inspection and engine for excessively long peri- service. If the snowmobile must be stored outdoors, position the snowmobile out of direct sun- light; then block the entire snowmobile off the ground making sure the snowmobile is secure. Inside Front Cover Starting and Stopping Engine. The problem is that once you have gotten your nifty new product, the arctic cat 2010 z1 turbo lxr service manual download gets a brief glance, maybe a once over, but it often tends to get discarded or lost with the original packaging. For a complete list of accessories, refer to the current Arctic Cat Accessory Cata- log. I think this is a indication of miss wiring.
Temper the wear strips by driving the snowmobile for approximately a mile on a hard pack trail; then immediately drive into deep snow and allow the wear strips to cool. How- increase the air spring force; ever, Arctic Cat recommends that the reducing pressure will shock spring be maintained at the fac- decrease air spring force. Once the drive belt is at room tem- perature, install the drive belt. I remember something about removing a stopper on the track and then lifting off. Is it your tail light or break light or both? Right now, when the high beams are switched on, the gauges reset and sweep, just like when you first turn it on. If not under warranty, this tle system resulting in a loss of return. Please read the following information completely.
I gather it's in the bundle out of the fuse box, right? No warranty will be areas, oxygenates either ethanol or allowed by Arctic Cat Inc. Using the measurement obtained tain positive steering characteristics, in step 2, make a horizontal mark Arctic Cat recommends that the ski on the aiming surface. Is it your tail light or break light or both? Place the taillight cover into position and secure with the 5. This engine does not require any pre-mixed fuel during the break-in period. The problem is that once you have gotten your nifty new product, the arctic cat 2010 z1 turbo sno pro le pdf service shop manual gets a brief glance, maybe a once over, but it often tends to get discarded or lost with the original packaging.
Couple Other Questions for you on the fuse blowing. Using appropriate stud template Accelerated wear strip wear caused by see chart , mark the desired stud operating on hard-packed snow condi- pattern to be used. If not under warranty, this service is at the discretion and expense of 0741-334 the snowmobile owner 3. Install the housing and secure 4. Lose tail light and brake light. Never substitute or disc; however, after a period of mix different types or grades of time, the pressure applied to the b r a ke f l u i d. .