Remove the full-length expansion board. The information contained herein is subject to change without notice. All single-bit failures and some multi-bit failures can be corrected without resulting in system downtime. Secure the cables to the cable management arm. If you select interactive mode, follow the instructions on the screen.
The information contained herein is subject to change without notice. Removing the drive does not cause a logical drive to fail. Remove the access panel on page 24. If you make any changes, click Analysis. Crash dump log analysis is an essential part of diagnosing reliability problems, such as hangs in operating systems, device drivers, and applications. Controller options The server ships with an embedded Smart Array P420i controller.
Use best practices when routing power cords and other cables. Connect each power cord to the server. Activity ring Rotating green Drive activity. Slide the server into the rack. The server then deactivates the failing rank and automatically switches over to the online spare rank. Verify that the processor is fully seated in the processor retaining bracket by visually inspecting the processor installation guides on either side of the processor. Connect each power cord to the power source.
Connect the power and data cable to the system board and the optical drive. For operating instructions, see the encryption technology feature documentation provided by the operating system. Remove all power: Disconnect each power cord from the power source. Install the access panel Place the access panel on top of the server with the hood latch open. The only two valid fan configurations are listed in the following table. Everything needed to manage and install the system software and firmware is preloaded on the server. Remove the air baffle on page 32.
Connect each power cord to the server. Removing the drive causes one or more of the logical drives to fail. Scripted online update for Linux serverThis is a method that updates all of the software components for an online Linux server in a scriptedmethod using an answer file. The utility does not prompt you for confirmation of settings before you exit the utility. The display enables diagnosis with the access panel installed. Connect each power cord to the server. Für bestimmte Standorte ist eine Lieferung am selben Tag oder innerhalb von vier Stunden gegen einen Aufpreis verfügbar.
Extend the server from the rack on page 23. Install the access panel on page 25. Install the access panel on page 25. Install the hard drives and hard drive blanks. Flashing blue The drive carrier firmware is being updated or requires an update.
Connect each power cord to the server. Disconnect each power cord from the server. Connect each power cord to the power source. To replace the component, reverse the removal procedure. Remove the clear processor socket cover. Drive status Solid green The drive is a member of one or more logical drives.
To operate properly, the server must have a supported operating system. Remove all power: Disconnect each power cord from the power source. Install the access panel on page 25. Power up the server on page 23. Power up the server on page 23.